This boat hull named WaveChopper30. It was designed for rough water. It is hand laid fiberglass mono deep V hullNote 1. Surface gel coated.
- Length: 742mm(29.2 inch)
- Width: 232mm(9.1 inch)
- Height: 140mm(5.5 inch)
- Weight: 820g(1lb and 12.5oz)
This boat hull equiped with a hatch latch, make hatch fixing easier. The transom back plate is made of 2 layers of fiberglass. Very strong, can stand with strongest motor. Good for mounting outboard engineNote 2. Also make the deck to bottom join stronger.
Surface propulsionNote 1 setup recommended but not necessary(surface vs subsurfaceNote 1). With surface propulsion set up, the boat can gain more speed. Good for .12 to .45 engine powered or electric poweredNote 2.
See some set up ideas by some customersNote 2 and set up ideas by the sellerNote 2.
See pictures of the items sold earlier. See how the prototype was made.
Three picturesNote 2 by Mark,USA:
Mirror like surface as soon as the components are released from the mould: Note 2.
Can clearly reflect an image: Note 2. The pictures do not show the detail.
Removing air bubbles is one of the very time consuming tasks
The mould stand has background light help spot out air bubbles, hence removed: Note 2
This picture taken from while making a yellow hull and background light switched on: Note 2
There is no stringers on the hull. Preinstalled stringers difficult dimension marking and drilling. Rear portion of the transom is a straight line. Making good fit stringers are easy. Dimension marking and drilling in a piece of straight hard wood are easy. See bottom three pictures of the left table. Assemble the engine, engine mount and stringers. Place the assembly in the compartment, apply epoxy to fix the stringers in position. This is far more easier than working with preinstalled stringers. Moreover, this allow more choices on engine mount. Some example drawings of the stringers: example 1, example 2. This is for example 2.
Packing material is carton box. The parcel gross weight will be approximately 1.5kg.
Note 1: A third party web page.
Note 2: NOT THE AUCTION/SELLING ITEM. Demonstration only.
1: The boat hull shell interior may have some raised fiberglass which can impale skin. When touching the shell interior, must wear a glove (kitchen type glove is enough).
2: This product is not a toy. Not recommended for people under 18 years old.